1 3

Keenworth

Arbiair White SC

Arbiair White SC

Arbiair White SC is a white airbrush ink base that is ideally for use on black or dark colored substrates, providing exceptional white opacity for striking results. It can also be used as underbased white.

View full details

Additional Information

Highlights

  • Soft-hand feel
  • Good washing fastness
  • Good printability and stability on screen
  • Easy cleanup with soap and water
  • Dual-purpose usage, airbrush and screen-print

Application

Arbiair series is compatible with airbrush tool and direct-to-textile printing on cut-piece articles and ready-to-wear outfit.

Material Compatibility

  • 100% Cotton
  • 50/50 Cotton-polyester blend
  • 50/50 Cotton-synthetic fiber
  • Calico/Canvas

Screen Mesh

(For screen-printing) 80T-120T, monofilament

Instruction

For Airbrush Procedure

  1. Prepare your airbrush/pen tool. Preferably use the double action type for greater control and easy clean, as a single action has less moving parts. Ideally, use at least a 100 P.S.I. air compressor and then prepare your inks and practice controlling atomization.
  2. On use of color, clean the airbrush tool to prevent colors from mixing in the airbrush. Blow water out on a rag or a piece of scratch paper.
  3. Wash out the airbrush tool immediately after you are done painting. Make sure to disassemble carefully for a sure clean.


For Screen-printing Procedure

  1. The printing process can be done either manual or via automatic screen-printing. Suggested maximum of three [3] strokes, three [3] coats, except when printing tonal or CMYK process.
  2. In halftone print, one [1] stroke is ideal but two [2] strokes are acceptable, however, one [1] coat only is highly suggested.
  3. Curing is recommended to greatly increase washing fastness. Curing will also give the print a glossier print output.

Recommended Curing Parameters

  • Drying time : 10 seconds
  • Temperature : 110ºC (230ºF)
  • Equipment : Heat press/oven/flash cure
  • Pre-curing : Heat gun

Time and temperature may vary depending on the curing equipment used.

Clean Up

Wash materials used with soap and water. Observe all local regulations when disposing of this substance.

Storage & Handling

Store tightly covered at temperatures between 10ºC – 30ºC (50ºF – 86ºF) and a relative humidity between that of 25% to 70%. Keep away from direct sunlight or high temperatures.

Important Note
This technical data sheet does not replace the Safety Data Sheet and should be used according to its recommended purpose. Any person using the product other than that specifically recommended does so at his own risk.

While we endeavor to ensure that all recommendations about our products are correct, many factors may affect the application of the product. It is advised that the quality of the substrate, the condition of the curing method, and other printing characteristics brilliance before mass production.
Disclaimer
The information and recommendation in this publication are to the best of our knowledge, information, and belief accurate at the date of publication. Nothing herein is to be construed as a warranty, express or implied.

In all cases, it is the responsibility of users to determine the applicability of such information or the suitability of any products for their own particular purpose. Therefore, we do not accept any liability whatsoever or howsoever arising for the performance of the product or for any loss or damage incurred out of the use of the product.

The information contained herein is liable to modification from time to time in light of continuous product development or improvements.