Printint Clear PT

Packaging: 20K, 4K, 1K, 500g, 250g, 125g

A two-in-one clear or transparent base that can be used for screen printing or for several dye methods. It is most often used to dye substrates with different dye-techniques to create colorful and unique designs.

Dual-purpose
Good washing fastness
Can be used for dyeing (tie-dye, dip-dye, etc.)
Brilliant color output
Soft-hand print output
Easy cleanup with soap and water

Screen Printing and dyeing techniques.

• 100% Cotton
• Cotton dominant-polyester blend
• Cotton dominant-synthetic fiber
• Calico/Canvas

Low Gloss

PRC Pigment

Photo Flash 300E

For screen printing: 100T – 120T, monofilament (for screen printing)

Square edge, medium durometer

Drying time : 10 seconds

Temperature : 110ºC (230ºF)

Equipment : Heat press/oven/flash cure

Pre-curing : Heat gun

Thickener ASE : For screen printing (1%-2%)

Reducer CT : For screen printing (1%-2%)

Fixer MR15 : For screen printing (1%-2%)

Fabric Dyeing Procedure

Dilute ink with 10% – 80% water depending on the desired color concentration.

For screen-printing (manual), it is important to maintain medium pressure and speed with a 45º angle. Do not dilute with water. Apply one layer and semi-cure. Repeat if necessary then proceed to final curing via curing equipment or machine.

Cleanup

Wash materials used with soap and water. Observe all local regulations when disposing of this substance.

Storage Condition

Store tightly covered at temperatures between 10ºC – 30ºC (50ºF – 86ºF) and a relative humidity between that of 25% to 70%. Keep away from direct sunlight or high temperatures.

Find the dealer nearest you.

Keep scrolling for additional information

Additional Information

Print according to color sequence. A ready-mixed base is recommended to beginners on screen-printing. Otherwise, you can mix the color yourself. Just ensure not to incur over-pigment load.

To achieve a smooth surface print, heat press curing is recommended.

To achieve good color opacity and brilliance during screen-printing (manual), maintain medium pressure and speed with a 45º to 60º angle.

Keep the screen wet by flooding the screen with just the right amount of ink or keep the screen clean.

Important Note

This technical data sheet does not replace the Safety Data Sheet and should be used according to its recommended purpose. Any person using the product other than that specifically recommended does so at his own risk.

While we endeavor to ensure that all recommendations about our products are correct, many factors may affect the application of the product. It is advised that the quality of the substrate, the condition of the curing method, and other printing characteristics brilliance before mass production.

Disclaimer

The information and recommendation in this publication are to the best of our knowledge, information, and belief accurate at the date of publication. Nothing herein is to be construed as a warranty, express or implied.

In all cases, it is the responsibility of users to determine the applicability of such information or the suitability of any products for their own particular purpose. Therefore, we do not accept any liability whatsoever or howsoever arising for the performance of the product or for any loss or damage incurred out of the use of the product.

The information contained herein is liable to modification from time to time in light of continuous product development or improvements.