Arbitrans KL

Packaging: 20K, 4K, 1K, 500g, 250g, 125g
Flock paper transfer
Flock paper transfer
Foil paper transfer
Foil paper transfer
Foil paper transfer and prints.
Foil paper transfer and prints.
Previous image
Next image

Transluscent water-base ink used for transfer print on light to dark ground substrates.

• Used on 3 types of transfer paper (Reflective, flock, foil)
• Good washing fastness
• Soft-hand feel
• Easy cleanup with soap and water

Flock paper transfer
Flock paper transfer
Foil paper transfer
Foil paper transfer
Foil paper transfer and prints.
Foil paper transfer and prints.
Previous image
Next image
  • Application
Direct to textile printing. For cut-piece articles and ready-to-wear.
  • Material Compatibility
• 100% Cotton
• 50/50 Cotton-polyester blend/synthetic fiber
• Calico/Canvas
  • Gloss/Luster
Not Applicable
  • Pigment Type
Not Recommended
  • Emulsion
Photo Flash 300E
  • Screen Mesh in cm
80T – 120T, monofilament
  • Squeegee
Square edge, medium durometer
  • Recommended Curing Parameters
Drying time : 10 seconds
Temperature : 110ºC (230ºF)
Equipment : Heat press/oven/flash cure
Pre-curing : Heat gun
  • Additives
Thickener ASE : Not recommended
Reducer CT : Not recommended
Fixer MR15 : Not recommended
  • Browse through our...
Textile Inks
Additives & Auxiliary Chemicals
Accessories

Printing Procedure

After curing, peel the transfer paper once it has cooled down, and then cure again without the transfer sheet (unless necessary). This also helps improve washing fastness of the print. For final curing, it is advisable that heat press machine is used instead of flat iron for even or balance curing.
All transfer prints have a tendency to wash-off after some washings. It is recommended that during laundry, the substrate is washed inside-out to make the print last longer.

Cleanup

Wash materials used with soap and water. Observe all local regulations when disposing of this substance.

Storage Condition

Store tightly covered at temperatures between 10ºC – 30ºC (50ºF – 86ºF) and a relative humidity between that of 25% to 70%. Keep away from direct sunlight or high temperatures.

Find the dealer nearest you.

Click Here

Keep scrolling for additional information

Additional Information

Heat press curing is recommended.

Maintain medium pressure and speed with a 45º to 60º angle.

Keep the screen wet by flooding the screen with just the right amount of ink or keep the screen clean.

Important Note

This technical data sheet does not replace the Safety Data Sheet and should be used according to its recommended purpose. Any person using the product other than that specifically recommended does so at his own risk.

While we endeavor to ensure that all recommendations about our products are correct, many factors may affect the application of the product. It is advised that the quality of the substrate, the condition of the curing method, and other printing characteristics brilliance before mass production.

Disclaimer

The information and recommendation in this publication are to the best of our knowledge, information, and belief accurate at the date of publication. Nothing herein is to be construed as a warranty, express or implied.

In all cases, it is the responsibility of users to determine the applicability of such information or the suitability of any products for their own particular purpose. Therefore, we do not accept any liability whatsoever or howsoever arising for the performance of the product or for any loss or damage incurred out of the use of the product.

The information contained herein is liable to modification from time to time in light of continuous product development or improvements.